ASSEMBLING THE FIXTURE (Fig. 1)
1. Carefully remove the fixture from the carton and check that
all parts are included as shown in the illustration.
2. Thread the loop (J) onto the nipple (K). Tighten the loop (J).
3. Spread the arms (S) so that the arms (S) are at equal
distance from each other.
4. Thread the nut (M) onto the nipple (N), then thread the
nipple (N) into the coupling (L), and tighten with the nut
(M).
5. Slide the tube (O), cap (P) and washer (Q) over the
nipple (N) and secure with the nut (R). Note: To avoid
scratching the tube (O), spread the arms (S) outward
to a suitable position.
6. Place the glass (U) over the socket (V), and secure in place
with retaining ring (T).
HANGING THE FIXTURE (Fig. 2)
7. Shut off the power at the circuit breaker and remove old
fixture from ceiling, including the mounting bar.
8. Thread the nipple (E) into screw collar (G) until snug.
9. Thread hex nut (D) onto nipple (E), place lock washer (C)
over end of nipple (E), thread nipple (E) through mounting
bar(A), and continue until tight.
10. Take this mounting bar (A) assembly and mount to ceiling
junction box with junction box screws (B). Tighten screws
securely with screwdriver.
11. Using a pair of pliers to open the end of chain (I), and
connect it to the loop (J), and close it.(Fig.2)
12. By measuring, determine correct number of links needed
for proper hanging height. Using the pliers, disconnect and
discard remaining chain.
13. Lace the fixture wires through the chain links. Slip screw
collar ring (H) over the chain, then do the same with the
canopy (F).
14. Open the other end link of the chain (I) (provided) and
connect it to screw collar (G). Close the link.
15. Feed the fixture wires through the screw collar (G) and
nipple (E) and pull until taut.
CONNECTING THE WIRES (Fig. 3)
16. At this point, connect the electrical wires as shown in
(Fig. 3) making sure all wire nuts are secured. You may
have to wrap the connections with electrical tape. If your
outlet has a ground wire (green or bare copper) connect
fixture’s ground wire to it. Otherwise connect fixture’s
ground wire directly to the mounting bar (A) using the green
screw provided.
17. Tuck these wire connections neatly into the ceiling junction
box and then raise the canopy (F) all the way to the ceiling.
Raise the screw collar ring (H) and thread onto screw collar
(G) protruding through canopy (Fig.2).
18. Install the light bulbs in accordance with the fixture’s
specification.
(DO NOT EXCEED THE SPECIFIED WATTAGE!) (NE PAS
DEPASSER LA PUISSANCE NOMINALE MAXIMALE!)
Your installation is now complete. Return power to the
junction box and test the fixture.
(1 pages)
(1 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals