Minka Lavery 9147-407 Instruction Manual download pdf

INSTALLATION INSTRUCTIONS

Model # 9147

READ AND SAVE THESE INSTRUCTIONS

WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.

Shut off power at the circuit breaker and remove old

fixture including mounting hardware.

Carefully unpack your new fixture and lay out all the

parts in a clear area. Take care not to misplace any

small parts necessary for installation.

3. Make two holes on the wall in correct position

accordance with the long strap (C) and the outlet box

(A), then insert the anchor (E) into the hole.

4. Pull black and white wires out of electrical outlet box

(A).

5. Thread the four studs (B) into the pre-

drilled holes in the

long strap (C) spaced the same distance apart as the

holes in the back plate (F).

6. Attach long Strap (C) using Outlet Box Screws (D

) to

the outlet box (A)

, screw the wood screws (G) into the

anchor (E) (Fig 1).

7. Connect the electrical wires as shown in Fig.2. M

aking

sure that all wire conne

ctors are secured. If your outlet

box

has a ground wire (green or bare copper), connect

the fixture ’s Ground wire to it. Otherwise,

connect the

fixture’s Ground wire directly to the long strap

using the

Green Screw (H) provided.

8. To prevent moisture from entering the outlet box (A)

and causing a short, use clear silicone Sealant to

outline the outside of fixture back plate (F) where it

meets the wall leaving a space at bottom to allow

moisture a means to escape.

9. Place the back plate (F) into stud (B) and secure it

tightly against the wall using cap nut (I). (Fig 1)

10. At this point, screw the extended nut (N), remove the

cage (M) to i

nstall the light bulbs in accordance with the

fixture specification. –-DO NOT EXCEED THE

MAXIMUM WATTAGE RATING!

11. Replace the cage (M), tighten with the extended nut

(N),then screw the nipple(O) and secure with the bottom

finial(P).

12. Replace the rubber washer (L), secure the top finial (J)

with the nipple (K).

Your installation is now complete. Return power to the

outlet box and test the fixture.

Fig. 1

BARE COPPER(GROUND)

Fig.2

FIXTURE

WIRES

WHITE

BLACK

(HOT)

WIRES

HOUSE

GREEN OR

WHITE

(NEUTRAL)

WIRES

HOUSE

(GROUND)

COPPER

BARE

FIXTURE

WIRES

BLACK

WIRES

FIXTURE

GREEN OR

HOUSE

WIRES

“CAUTION

RISK OF FIRE

CONSULT

QUALIFIED ELECTRICIAN TO ENSURE

CORRECT BRANCH CIRCUIT CONDUCTOR”

INSTALLATION INSTRUCTIONS 1

Summary of Contents

Page 1 - INSTALLATION INSTRUCTIONS

INSTALLATION INSTRUCTIONS Model # 9147 READ AND SAVE THESE INSTRUCTIONS WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER. 1. Shut off po

Comments to this Manuals

No comments

Minka Lavery 9147-407 Instruction Manual

Browse online or download Instruction Manual for Unknown Minka Lavery 9147-407. Minka Lavery 9147-407 Instructions / Assembly User Manual

Summary of Contents

Comments to this Manuals

Related products and manuals for Unknown Minka Lavery 9147-407