Minka Lavery 4965-284 Instruction Manual download pdf

INSTALLATION INSTRUCTIONS FOR FIXTURE #4965

ASSEMBLING THE FIXTURE (FIG. 2)

1. Shut off the power at the fuse box or circuit breaker. If

necessary, remove the old fixture from the ceiling including the

mounting hardware.

2. Carefully remove the new fixture from carton and check that all

parts are included as shown in the illustration.

3. Thread the fixture loop (A) tightly onto the nipple (B).

4. Adjust the fixture arms to their proper position.

5. Place the glass shade (E) over the socket (F), then secure with

the cushion ring (D) and socket ring (C).

6. Install the light bulb in accordance with fixture’s specifications.

(DO NOT EXCEED THE MAXIMUM WATTAGE RATING!) (NE

PAS DEPASSER LA PUISSANCE NOMINALE MAXIMALE!).

MOUNTING THE FIXTURE (FIG.1)

1. Thread the nipple (S) into the collar loop (T) until snug.

2. Thread the other end of nipple (S) into the cross bar (P).

3. Place lock washer (Q) over the end of nipple (S) protruding

through the cross bar (P) and thread hex nut (R) onto nipple (S)

until tight.

4. Take this crossbar assembly and mount to ceiling outlet box (V)

tightly using outlet box screw (W). The side of the cross bar

marked “GND” must face out.

5. Use proper chain pliers to open one end link of the chain and

connect to the fixture loop (A). Close the link.

6. By measuring, determine the correct number of links needed for

proper hanging height. Using the chain pliers, disconnect and

discard the remaining chain.

7. Carefully lace the fixture wires through the chain (X).

8. Slip collar ring (Y) over the chain (X), then do the same with

canopy (U).

9. Open the other end link of the chain (X) and connect to the collar

loop (T). Close the link.

10. Feed the fixture wires through the collar loop (T) and nipple (S)

and pull until tight.

CONNECTING THE WIRES

1. At this point, connect the electrical wires as shown in the wiring

diagram, making sure that all wire connectors are secured. If

your outlet box has a ground wire (green or bare copper),

connect the fixture’s ground wire to it. Otherwise, connect the

fixture’s ground wire directly to the cross bar using the green

screw provided.

2. Tuck these wires connectors neatly into the ceiling outlet box

and raise the collar ring (Y) and thread onto collar loop (T)

protruding through canopy.

Your installation is now complete. Return power to the outlet box

and test the fixture.

SOCKET(F)

SOCKET RING(C)

LOOP(A)

NIPPLE(B)

Fig. 2

Fig. 1

WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.

AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR.

Set A#A-010

-Crossbar

-Ground Screw

-Mounting screws (2)

Chain # HCH3072-84

Gauge 4.5MM

(SKT-RING-26)

Summary of Contents

Page 1 - NIPPLE(B)

INSTALLATION INSTRUCTIONS FOR FIXTURE #4965ASSEMBLING THE FIXTURE (FIG. 2)1. Shut off the power at the fuse box or circuit breaker. Ifnecessary, remov

Comments to this Manuals

No comments

Minka Lavery 4965-284 Instruction Manual

Browse online or download Instruction Manual for Unknown Minka Lavery 4965-284. Minka Lavery 4965-284 Instructions / Assembly User Manual

Summary of Contents

Comments to this Manuals

Related products and manuals for Unknown Minka Lavery 4965-284