Minka Lavery 4499-298 Instruction Manual download pdf

ASSEMBLY THE FIXTURE (FIG. 1)

1. Shut off the power supply at the fuse box or circuit breaker.

Remove the old fixture from ceiling, including the old cross

bar.

2. Carefully unpack your new fixture and lay out all the parts in a

clear area. Take care not to lose any small parts necessary for

installation.

3. Thread the center tube (N) onto the nipple (O) tightly, then put

the decorative arm (P) over the top end of the center tube (N).

4. Insert the bottom end of the tube (I) onto the pin (M), then

protrude the top end of tube (I) through the hole on the

decorative arm (P), and tighten with decorative nut (H).

5. Put the canopy (F), lock washer (E) onto the center tube (N),

and secure with hex nut (D).

6. Assemble the fabric shade (R) onto the fixture arm using

screw with nut (Q) well.

7. Put the glass shade (K) over the socket (L) and secure with

socket ring (J).

8. Install the bulbs in accordance with the fixture’s specifications.

DO NOT EXCEED THE MAXIMUM WATTAGE RATING!

MOUNTING THE FIXTURE

9. Attach the universal mounting plate (B) to the outlet box using

the outlet box screws (A). The side of the mounting bar

marked “GND” must face out.

10. Follow the wiring instructions carefully (See Fig.2).

11. Attach the fixture main body onto the universal mounting plate

(B) by protruding 2 mounting screws (C) through the mounting

holes of the ceiling canopy (F) and secure with ball nut (G).

Wiring (See fig.2)

1. Connect the electrical wires as follows. Connect the black

wire from the fixture to the black (HOT) house wire. Connect

the white wire from the fixture to the white (Neutral) house

wire. Make sure all the wire nuts were secured. You may wrap

the connections with electrical tape. If your outlet box has a

ground wire (Green or Bare Copper) connect fixture’s ground

wire to it. Other wise attach the bare copper fixture wire to the

green ground screw on the mounting bar.

2. Tuck the wire connections neatly into the ceiling junction box.

Your installation is now complete. Turn on the power supply of

the junction box to test the fixture.

Fig.1

SOCKET RING(J)

GLASS SHADE(K)

SOCKET(L)

NIPPLE(O)

CENTER TUBE(N)

TUBE(I)

DECORATIVE ARM (H)

BALL NUT(G)

CANOPY(F)

LOCK WASHER(E)

HEX NUT(D)

DECORATIVE ARM(P)

STUD(M)

GROUND S CREW

SCREW WITH NUT(Q)

FABRIC SHADE(R)

FIXTURE ARM

INSTALLATION INSTRUCTION FOR FIXTURE# 4499-298

READ AND SAVE THESE INSTRUCTIONS

ARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.

GROUND S CREW 1

Summary of Contents

Page 1 - GROUND S CREW

8 ASSEMBLY THE FIXTURE (FIG. 1) 1. Shut off the power supply at the fuse box or circuit breaker. Remove the old fixture from ceiling, including the

Comments to this Manuals

No comments

Minka Lavery 4499-298 Instruction Manual

Browse online or download Instruction Manual for Unknown Minka Lavery 4499-298. Minka Lavery 4499-298 Instructions / Assembly User Manual

Summary of Contents

Comments to this Manuals

Related products and manuals for Unknown Minka Lavery 4499-298