Minka Lavery 950-126 Installation Guide download pdf

INSTALLATION INSTRUCTION FOR 950-126

WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER .

Fig.1

Fig.2

MOUNTING THE FIXTURE(Fig.1)

1. Shut off the power at the circuit breaker box. Remove

old fixture and all hardware from Junction Box.

2. Carefully unpack your new fixture and lay out all the

parts on a clear area. Take care not to lose any small

parts necessary for installation.

3. Thread the two Studs(A) about 1/4”into the pre-drilled

holes in the Crossbar spaced the same distance apart as

the holes in the fixture canopy(B).

4. Install the mounting strap to the Junction Box with the

two Junction Box Screws as shown. The side of the

mounting strap marked

GND

must face out.

5. While holding the canopy and lamp cluster towards the

ceiling, connect the electrical wires as Shown in Fig.2,

making sure that all wire connectors are secured. You

may have to wrap the connections with electrical tape.

If there is a Ground Wire (green or bare copper)in your

outlet box, connect the fixture’s Ground Wire to it.

Otherwise connect fixture’s ground wire directly to the

mounting strap with the Green Screw provided. After

wires being connected, tuck them carefully inside the

Junction Box.

6. Connecting center part(G) to lamp body(H) and turn

clockwise until firmly tightened.

7. Connecting center part(F) to part(G) and turn clockwise

until firmly tightened.

8. Connecting center part(E) to part(F) and turn clockwise

until firmly tightened.

9. Connecting center part(D) to part(E) and turn clockwise

until firmly tightened.

10. Connecting canopy(B) to part(D) and turn clockwise

until firmly tightened.

11. Then cover the junction box with canopy (B), aligning

the Screw of mounting plate with the hole of canopy

and lock it with brass ball(C).

12. Place Shade(I) onto the socket of fixture body(H) then

secure it in, place with Screw Shell (K) and ring (J)

securely tighten.

Your installation is now complete. Return power to the

junction box and test the fixture.

american

lighting

association

MOUNTING THE FIXTURE(Fig.1) 1

Summary of Contents

Page 1 - MOUNTING THE FIXTURE(Fig.1)

INSTALLATION INSTRUCTION FOR 950-126 WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER . Fig.1 Fig.2 MOUNTING THE FIXTURE(Fig.1) 1. Shu

Comments to this Manuals

No comments

Minka Lavery 950-126 Installation Guide

Browse online or download Installation Guide for Unknown Minka Lavery 950-126. Minka Lavery 950-126 Installation Guide User Manual

Summary of Contents

Comments to this Manuals

Related products and manuals for Unknown Minka Lavery 950-126