INSTALLATION INSTRUCTION FOR 5328-577
WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER .
AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR.
READ AND SAVE THESE INSTRUCTIONS
PREPARATION
1. Shut off the power at the circuit breaker box. If
necessary, remove the old fixture and all
mounting hardware from junction box.
2. Carefully unpack your new fixture and lay out all
the parts on a clear area. Take care not to loose
any small parts necessary for installation.
ASSEMBLING THE FIXTURE (Fig. 1)
3. Spread the arms (J) so that the arms (J) are at
equal distance from each other.
4. Secure the part (I) of the decorative arms (F) to
the canopy (D) with the screws (G), then secure
the part (II) of the decorative arms (F) to the
coupling (I) with the screws (G).
5. Thread the nut (L) onto the nipple (M), then thread
the nipple (M) into the coupling (K) and tighten
with the nut (L).
6. Install the light bulb(s) in accordance with the
fixture’s specifications (DO NOT EXCEED THE
MAXIMUM WATTAGE!) (NE PAS DEPASSER
LA PUISSANCE NOMINALE MAXIMALE!)
7. Slide the glass (N), plastic washer (O) and iron
washer (P) over the nipple (M) and secure with
the nut (Q).
8. Slide the cap (R) over the nipple (M), and secure
with the finial (S).
MOUNTING THE FIXTURE (Fig.1)
9. Thread the two mounting screws (A) (Size: #8-
32*1.1”L) part way into the crossbar (B). Secure
the crossbar (B) to junction box (not provided)
with the junction box screws (C) (Size: #8-
32*0.6”L) through the slotted holes in mounting
bar (B). The side of the mounting bar (B) marked
“GND” must face out.
CONNECTING THE WIRES (Fig. 2)
10. Connect the fixture wires to the junction box wires
as shown in Fig. 2, making sure all wire
connectors are secured. If your outlet box has a
ground wire (green or bare copper) connect the
fixture’s ground wire to it. Otherwise, connect the
fixture’s ground wire directly to the mounting plate
using the green screw provided. After the wires
are connected, tuck them neatly inside the
junction box.
COMPLETING THE INSTALLATION (Fig. 1)
12. Raise the canopy (D) allowing for the mounting
screws (A) to protrude through the holes on the
canopy (D), then secure with the finials (E).
Return the power to the junction box and test the
fixture. Your installation is now complete.
Fig.1
Fig . 2
Set
#
-Crossbar
-Ground screw
-Mounting screw*2
-
n
ti
n
x
r
w
*
A-
(1 pages)
(1 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals