Minka Lavery 1566-477 Installation Guide download pdf (Page 1)

INSTALLATION INSTRUCTION 1565-477 1566-477

For Flush Mount Ceiling Fixtures

WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER .

Fig.1

Fig.2

MOUNTING THE FIXTURE

1. Shut off the power at the fuse box or circuit breaker box.

Remove the old fixture from ceiling, including the crossbar.

2. Carefully unpack your new fixture and lay out all the parts

on a clear area. Take care not to lose any small parts

necessary for installation.

3. Thread the two Mounting Screws (A) about 1/4” into the

pre-drilled holes in the Crossbar (B) spaced the same

distance apart as the holes in the pan (E).

4. Attach the crossbar (B) to the outlet Box using the two

screws (C) from the outlet Box. The side of the crossbar

marked "GND" must face out.

5. Hold the fixture (D) and pan (E) towards the crossbar and

connect the electrical wires as follows (See Fig.2). Connect

the black wire from the fixture to the black house (hot)

wire; connect the white wire from the fixture to the white

house (neutral) wire. Make sure all wire nuts are secured.

You may wrap the connections with electrical tape.

If your

outlet box has a ground wire (green or bare copper) connects

fixture’s ground wire to it. Other wise attach the bare copper

fixture wire to the

green ground screw on the crossbar. Tuck

the wire connections neatly into the ceiling junction box as

you are holding the fixture assembly toward the ceiling.

6. Finish mounting the pan (E) by placing it over both

Mounting screws (A) so that the screws protrude from the

keyholes in the bottom of the pan (E). Rotate the pan (E)

until the screw are seat in the slots of the keyholes and

tighten it with a screwdriver.

7. Install the light bulbs in accordance with the fixture’s

specifications. DO NOT EXCEED THE MAXIMUM

WATTAGE RATING!

8. Thread pipe (G) into center coupling of the pan (E) and

tighten it with nut (F).

9. Put the glass shade (H) onto the fixture (D) and protruding

the pipe (G) from the center hole of the glass shade.

10. Thread lock nut (I) onto pipe (G), then attach the finial

base (J) and tighten firmly with finial (K).

Your installation is now complete. Return power to the

junction box and test the fixture.

White or

HOUSE

Black

WIRES

(Hot)

Smooth

FIXTURE

WIRES

Black or

Ribbed

WIRES

FIXTURE

Bare Copper(Ground)

FIXTURE

WIRES

Copper

(Ground)

HOUSE

(Neutral)

WIRES

White

Bare

Green or

WIRES

HOUSE

Green Screw

MIN 90℃SUPPLY CONDUCTORS

MOUNTING THE FIXTURE 1
If your 1

Summary of Contents

Page 1 - If your

INSTALLATION INSTRUCTION 1565-477 1566-477 For Flush Mount Ceiling Fixtures WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER . Fig.1 F

Minka Lavery 1566-477 Installation Guide Page 1

Browse online or download Installation Guide for Unknown Minka Lavery 1566-477. Minka Lavery 1566-477 Installation Guide User Manual

Summary of Contents

More documents for Unknown Minka Lavery 1566-477

Comments to this Manuals

Minka Lavery 1566-477 Installation Guide Page 1

Browse online or download Installation Guide for Unknown Minka Lavery 1566-477. Minka Lavery 1566-477 Installation Guide User Manual

Summary of Contents

More documents for Unknown Minka Lavery 1566-477

Comments to this Manuals

Related products and manuals for Unknown Minka Lavery 1566-477